3 Common Ready Brute Problems (Troubleshooting)

ready brute problems
ready brute problems

Most people will enjoy camping trips if they bring their family or friends with them. Though, they also have to bring a lot of equipment with them which can get difficult to store.

Considering this, there are tons of options that they can go for which will fix this issue. One of the best solutions is to tow down a trailer with your vehicle.

This will be dragged along by you and you can store tons of equipment in the trailer. Though, when towing down a vehicle, you should note that the user has to equip their car or truck with a tow bar.

One of the best devices that you can purchase is the Ready Brute system. This is easy to install on your vehicle but there are also some issues that you can run into.

We will be using this article to provide you with a list of common problems that can be found on the Ready Brute tow bar along with its fixes.

Ready Brute Problems

  1. LED Lights Not Working

The Ready Brute towing system is one of the easiest pieces of equipment to install on your vehicle It takes a little time but you should not have much trouble if you follow the manual correctly.

Though, one common problem that people get into is with the small LED lights that you have to connect. These are made to indicate you whenever the brakes on your attached vehicle are applied.

This helps users to stop their vehicles and even find out if there are any problems with the system.

Though, the wires provided for these lights are quite small and weak. Many people have reported that the cables on their device eventually got damaged. Alternatively, they had a hard time trying to route it to their dashboard.

For both of these issues, you have to note that this is quite a common problem. If you are getting this then the only way to fix it is by purchasing a new set of wires.

You can easily find these from most electrical stores. But keep in mind that you select a good quality cable so that it lasts you a long time.

You can choose between the length of these cables and then route it according to the size of your vehicle. Finally, once the installation is complete, the user should no longer have the same problem again.

  1. Install A Separate Braking Mechanism

While installing a new pair of wires for your system will fix the issue with these lights. Most people find it annoying that the lights do not provide them with complete information about their vehicles stopping.

This can make it difficult for most users to drive around which is why people decide to install an automatic braking system on their towed vehicle.

This can be quite expensive to set up but will provide you with complete security. Additionally, you will have a much easier time driving around because you no longer have to worry about the braking system.

There are tons of companies that manufacture this and you can purchase it from either one. Though, make sure that you do the proper research beforehand to find a product that best suits your usage

. There are even people recommended systems on RV forums that you can check. Consulting with them should help you out a lot.

  1. Installation Problem

While the only two major issues that people have with this amazing device are with the lights on it. Some people can even find it difficult to install the system itself. You must tighten up the device carefully to prevent any issues with it while you driving.

This is why if you do not understand how this can be attached to your vehicle. Alternatively, if the user is hesitant then it is better that you take it to a workshop instead.

They should already know how to install this system and will do it for you. This will also ensure that there are no future problems with the device.

But keep in mind that you should keep a regular check over this system. This is because it can start to loosen up with time. After which you will have to tighten the screws on it again.

Leave a Comment