Going out on long camping trips requires people to carry a lot of equipment with them. This is because these devices are necessary for them to have a fun trip. You can make lots of new memories while also exploring new areas on these adventures. However, when it comes to carrying all of this equipment. You must have a large vehicle with you.
Usually, a car is not enough to store all of this which is why people purchase motorhomes and RVs instead. Aside from this, it is also important that you have some security features on your vehicle. The backup camera from Peak is amazing to use but it has some problems as well. Considering this, we will be using this article to provide you with a list of issues that you can get with this device along with ways to fix them.
Peak Backup Camera Problems
1. Check Display
The first thing that you should check on your Peak backup camera is its display. This is used to control the device and all of its features. Considering this, you can go through the settings on your display to confirm if there are any configuration errors. Make sure that you did not change anything that is now causing the issue you are getting.
Keep in mind that you can also adjust the different options provided to get a better display from your camera. Although, if you are unable to fix the problem you were getting. Then another option that you can go with is resetting the display. This will remove all of the changes you had made to your device bringing it back to its factory default state.
The process is quite simple and you can start by finding a small pin. Now hold this in the pinhole provided on your display and wait for a few seconds. The screen should switch off on its own which indicates that the camera is now being reset. It is recommended that you wait patiently for your display to reset as clicking any buttons can interrupt the connection. Once the device switches back on, you should be able to notice that your problem is now fixed.
2. Check Wires
Another problem that you can get on your backup camera is that it stops working all of a sudden. This can be quite annoying to deal with as the user is unable to check behind their vehicle when trying to reverse. Although, you should note that the most common reason for this issue is that the wires for your camera might have come off. There are small cables that are carrying the current for your display.
If even one of these breaks off then you will notice that the camera stops working. Considering this, it is best that you carefully observe the wirings on your display to confirm if any of these have come off. Simply connecting them back in will allow you to fix the issue. However, if there are any breaks or damages on the wires then you will have to get them replaced with new ones. You might be able to fix these on your own but it can be quite difficult to do this.
3. Faulty Camera
Finally, if your camera is still not working then there is a high chance that your camera has become faulty. There are tons of reasons that can cause this issue on your equipment. Although, trying to narrow down what the exact problem is can take a lot of time. This is why you should contact the support team for Peak. They will look into your issue and provide you with a viable solution. Make sure that you provide them with detailed information about your problem so that they can find it as soon as possible.
Additionally, if your camera was still under warranty then the company should be able to give you a free replacement. Some guidelines have to be followed for this. Most of these are provided to the user along with the product. This is why you must go through these carefully to ensure you understand the process. On the other hand, if your camera does not qualify for the warranty and it has been damaged. Then your only option is that you replace it with a new one.