3 Common Dometic Ice Maker Problems (Troubleshooting)

dometic ice maker troubleshooting
dometic ice maker troubleshooting

Dometic is a famous company that has been known for manufacturing some of the best motorhomes. There is a huge lineup of these vehicles that you can select from.

You can easily check all the specifications about your vehicle by visiting their official website. This should also help you in narrowing down your choice. While most features on these vehicles usually depend on what model you want to purchase.

There are some services that you will get on your Dometic vehicle no matter what lineup you go for. One of these is their ice makers. These small trays help you in making ice so that you can use them for your drinks or similar stuff.

Sometimes the ice maker in your vehicle can completely stop functioning. Any problems with it can be annoying, this is why we will be using this article to provide you with some troubleshooting steps for the Dometic ice maker.

Dometic Ice Maker (Troubleshooting)

  1. Check the Back of Your Refrigerator

The first thing that you should do is to check the back of your refrigerator. There might be some connections that might have come off or are loose. This is a really common problem and can happen if you have recently moved your device.

Alternatively, they can even come off on their own. This is why you should power off your refrigerator and move it forward to check the connections on it.

Make sure that none of them have been disconnected and tighten all of them up. Usually, the water tube can come off so keep in mind that you check it carefully. Also, look out for any damages or bents on it.

If there are any then either replace the tube with a new one or repair it. Lastly, keep in mind that you should carefully route these tubes so that there are no bends in them. These can easily stop the water from flowing through and can cause issues for the user.

  1. Check Current and Fuse

If the connections are all tight and you are still having problems with your ice maker. Then there might be a problem with the current coming to your refrigerator.

Take a voltmeter to check the values for your outlet. If these are lower than normal or are fluctuating then do not connect your device back into the same outlet again.

This can be dangerous and might even damage your appliance. Check another outlet and if the current on it is fine then connect your refrigerator to it. This should most likely fix the problem for you.

In case, there was no current coming to your outlet, the fuse in it might have died. These small devices usually cut the connection to prevent your electrical appliance from getting damaged.

Considering this, you can easily fix them by replacing the fuse in them. Some Dometic refrigerators also use fuses in them so you can also replace them if they have gone bad. One thing to keep in mind is that these require a certain amount of current.

You can check what values are supported by your fridge and then purchase a fuse according to it. This will help prevent any additional problems with your ice maker.

  1. Timer and Motor

The ice makers from Dometic use a timer on them which they follow. This prevents the device from staying on all the time and helps in saving energy. Consequently, the timer might be set to stay off during the time you checked the ice cubes on your refrigerator.

Make sure that you set it to a time when you fill in the water. This will help in having access to ice at all times. Even when the ice maker has been switched off by the timer.

Aside from this, another thing that you should check is the condition of the motor. IF there are any problems with it then your device will stop making ice cubes. You can easily get the motor replaced by contacting the company.

Having a warranty can help you out because some people might even get a free replacement. If you have run out of warranty then try to get the motor in your fridge repaired. Getting a new one can cost you a lot of money which is usually not worth it.

1 thought on “3 Common Dometic Ice Maker Problems (Troubleshooting)”

Leave a Comment